Made in the USA

Clean Sweep Gutter Protection System

About the Clean Sweep Gutter Protection System

For Systems That Keep Gutters Free From Debris
Now there’s an even better way to keep gutters clean and free-flowing…The Patent Pending Clean-Sweep™ Gutter Protection System.

1 - The back of the profile features a rubber based insert that is set at 450 angle to sit on top of the hangers for added support and to ensure positive drainage. The rubber is impervious to the damaging effects of hot and cold temperatures, which means it will not rot or become brittle.

2 - Opening width allows maximum rain water flow.

3 - A longer front lip is available that extends beyond the gutter to help prevent “tiger striping”. The drop in system does not lay beneath the shingles, which means it will never jeopardize the integrity of the roof or its structure.

Features of the Clean Sweep Gutter Protection System Include:

  • Prevents debris from clogging gutters and downspouts
  • An easy to install low profile design for an attractive, clean look
  • Deters water run-off that can damage a home’s exterior and foundation
  • Helps protect gutters from winter ice dams
  • 5 Beautiful standard colors: Clay, Wicker, White, Brown and Black.
    (additional colors may be available upon request)
Clean Sweep Gutter Protection System from C & J Manufacturing

 

Installation Instructions

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

  1. Clean and flush existing gutters and downspouts thoroughly with water prior to installing.
  2. Place the Clean Sweep Gutter Protection on top of the gutter with the rubber strip against the fascia or drip edge.
  3. Install front edge of Clean Sweep even with front of gutter and fasten with screws or rivets at 24” to 30”on center.  Factory overlap is required at each adjoining section of Clean Sweep gutter protection.  It is recommended that screws be installed near the back end of every overlapped section.

Installation Note:

  • It is recommended that the flow from high-level gutters must be drained with downspouts directly into lower-level gutters and sealed.